MWO-9-2300-378-34-2
TANK, COMBAT FULL-TRACKED
MODIFICATION WORK ORDER
JUNE 1984
MWO-9-2300-378-34-2 - Page 36 of 92
MWO 9-2300-378-34-2
Figure 22. Installation of Tube Clamp at Position 4
(16) Unscrew retaining nut from positive starter harness receptacle connector and
slide rubber bushing back over cables (figure 23).
Silicone compound (MIL-S-8660) may be
applied to cables to help bushing slide.
(17) Remove existing rubber plug and pin (male contact) from hole position ‘A’
(CKT 920A) of receptacle shell (figure 23).
.
(18) Apply silicone compound to solenoid positive lead and pin and thread through
retaining nut and bushing and insert pin into shell position ‘A’ (Figure 23).
(19) Slide rubber bushing up against shell and install retaining nut (figure 23).
34
Back to Top
