SMI-9-2320-387-14P-1
TRUCK, UTILITY: EXPANDED CAPACITY
SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS
JULY 2004
SMI-9-2320-387-14P-1 - Page 130 of 671
11-12.8. BALLISTIC CREW DOOR WINDOW PROTECTIVE SHIELD REPLACEMENT
This task covers:
a. Initial Installation
c. Installation
b. Removal
NOTE
• The following procedure can be performed to prevent damage to
door glass. This task can be accomplished with the approval of the
unit commander.
• Procedures for initial installation and replacement of the
protective shields are basically the same for all windows. This
procedure covers the left front protective shield.
NOTE
Initial installation steps apply only to vehicles that have not been
previously retrofitted with protective shields.
1.
Position protective shield (3) on inside of ballistic door (1).
2.
Using protective shield (3) as a template, locate and mark three top holes (2) and two bottom
holes (5) on inside of ballistic door (1).
NOTE
Ensure window is closed tightly before drilling holes for the
protective shield.
3.
Drill three 0.156-in. (0.396-cm) diameter holes (8) through ballistic door frame (9).
4.
Drill two 0.193-in. (0.490-cm) diameter holes (6) through ballistic door (1).
5.
Install protective shield (3) on ballistic door fame (9) with three screws (4).
6.
Install protective shield (3) on ballistic door (1) with two 5/32-in. blind rivets (7).
7.
Spot paint ballistic door (1) and protective shield (3) as necessary. Refer to TM 43-0139.
a. Initial Installation
INITIAL SETUP:
Applicable Models
M1151
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts (Cont'd)
Protective shield (Appendix D, Fig. D-39)
Two blind rivets (Appendix G, Item 265)
Two blind rivets (Appendix G, Item 262.1)
Manual References
TM 43-0139
TM 9-2320-387-24P
SMI 9-2320-387-14&P-1
11-24.12
Change 4
Back to Top
