TB-9-1000-234-13
EXERCISING OF RECOIL MECHANISMS AND EQUILIBRATORS
TECHNICAL BULLETIN
SEPTEMBER 2010
TB-9-1000-234-13 - Page 33 of 52
TB 9-1000-234-13
B-3
NOTE
Item 14 is the 6-inch turnbuckle and Item 15 is the 18-inch turnbuckle.
5. Remove pin (12) from each of two 5/8-inch shackles (13). Insert one 5/8-inch shackle into each of
two turnbuckle (14) eyes. Secure 5/8-inch shackles to cylinder support assembly (1) using two pins
(see figure B-2).
6. Remove pin (16) from each of two 1-inch shackles (17). Insert one 1-inch shackle into each of two
cab lifting eyes (18) and (19). Secure 1-inch shackle to each of two wire rope assembly (20)
thimbles using two pins.
7. Remove screw (21) and nut (22) from each of two turnbuckles (14). Insert each turnbuckle into wire
rope assembly (20) and secure with screw and nut.
8. Adjust two turnbuckles (14) evenly to remove slack from two wire rope assemblies (20).
Figure B-2.
Back to Top
