TB-9-1000-234-13

EXERCISING OF RECOIL MECHANISMS AND EQUILIBRATORS

TECHNICAL BULLETIN

SEPTEMBER 2010
TB-9-1000-234-13

  TB-9-1000-234-13 - Page 40 of 52

TB 9-1000-234-13
B-10
2. Loosen two turnbuckles (14) evenly to release tension on two wire rope assemblies (20) (see
figure B-7).
3. Remove screw (21) and nut (22) from each of two turnbuckles (14). Remove two wire rope
assemblies (20) from two turnbuckles. Install screw and nut in each of two turnbuckles.
4
Remove pin (16) from each of two 1-inch shackles (17) and remove two wire rope assemblies (20).
Remove two 1-inch shackles from two cab lifting eyes (18) and (19). Install pin in each of two 1-inch
shackles.
5. Remove pin (12) from each of two 5/8-inch shackles (13). Remove two 5/8-inch shackles from
cylinder support assembly (1) and remove two turnbuckles (14). Install pin in each of two 5/8-inch
shackles.
Figure B-7.


Back to Top