TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 126 of 460

TB 9-2320-279-13&P-2

HEADLIGHT AND COMPOSITE LIGHT REPLACEMENT - CONTINUED

0021 00

0021 00-4

CLEANING AND INSPECTION

Clean and inspect all parts IAW

General Maintenance Instructions

(WP 0011 00).

INSTALLATION (CONFIGURATION B)

NOTE

•

The following procedure covers both left and right headlight assemblies (Configuration B).

•

Left headlight assembly (Configuration B) is illustrated.

1.

Position headlight bracket (10) over mounting holes on lower brush guard.

2.

Install two washers (2) and bolts (1) in top of headlight bracket (10).

3.

Install three washers (8) and new locknuts (9) in bottom of headlight bracket (10).

4.

Install headlight adapter (12), five washers (15), bolts (14), washers (3), and new locknuts (4) in headlight bracket (10).

5.

Install front composite light (13), two washers (16), and bolts (17) in headlight adapter (12).

6.

Install headlight (11), three washers (7) and new locknuts (6) in headlight bracket (10).

7.

Connect jumper harness connectors (5) to headlight (11) and front composite light (13).

8.

If equipped, turn battery disconnect switch to ON position (TM 9-2320-364-10).

9.

Check operation of headlights and front composite lights (TM 9-2320-364-10).

417-133

13

12

11

10

9

8

7

6

5

4

3

2

1

17

16

15

14