TB-9-2350-277-40-P-3
CARRIER, MECHANIZED SMOKE OBSCURANT M58
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 3 OF 4
JUNE 2009
TB-9-2350-277-40-P-3 - Page 43 of 88
TB 9-2350-277-40&P-3
INSTALLATION PROCEDURES – Continued
0005 00
0005 00-9
INSTALL GPS ANTENNA CABLES AND GPS SENSOR CABLE
NOTE
Do not tighten cable clamps or secure cables with tie straps until
installation is complete and the cables have been adjusted at both
ends.
1.
Route GPS antenna cable N-type (44) from primary unit location up the turbine housing wall to
the roof.
2.
Continue routing GPS antenna cable N type (44) to the rear of the vehicle and through existing
clamps (46) and (47) to the GPS antenna riser hull opening.
3.
Route GPS antenna cable BNC-type (45) from primary unit location up the turbine housing wall to
the roof.
4.
Continue routing GPS antenna cable BNC type (45) along GPS antenna cable N type (44) to the
GPS antenna riser hull opening.
5.
Measure and pull GPS antenna cable N-type (44) to extend 10 inches beyond clamp (40) to
primary unit location.
6.
Measure and pull GPS antenna cable BNC-type (45) to extend 24 inches beyond clamp (40) to
primary unit location.
7.
Secure cable (45) to cable (44) with tie straps (4).
8.
Loop excess cables (44) and (45) at GPS antenna riser hull opening and secure tie strap (4).
Figure 8.
GPS Antenna Cables Installation
Back to Top
