TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 108 of 624
2-92
TB 9-2510-251-13
2-1.3
Installation of Air Conditioning Kit to M1025 and M1025A1 with GSIE Add-on-Armor
(Cont’d).
d. Install Refrigerant Hoses
CAUTION
•
When installing hoses, be sure to secure away from hot or moving parts.
Failure
to comply could result in damage to equipment.
•
Avoid routing hoses in areas where chafing, punctures, or pinching may occur.
Failure to comply could result in damage to equipment.
•
DO NOT remove caps from hoses until ready to charge air conditioning system.
Failure to comply could cause contamination of system and damage to
equipment.
•
Keep all fittings capped until just prior to connecting hoses.
Failure to comply
could result in damage to equipment.
•
Keep ends of hoses covered during routing to avoid contamination.
Failure to
comply could result in damage to equipment.
•
Before connecting fittings, check to see that O-rings are present and undamaged.
Failure to comply could result in damage to equipment.
•
Lubricate O-rings with mineral oil just prior to connecting fittings to components
or inserting fittings into hoses.
Failure to comply could result in damage to
equipment.
NOTE
•
Route hoses according to the diagram shown.
Follow existing routing
and tie strap to secure.
DO NOT connect any hoses at this time.
•
Use hydraulic caps or tape closed ends of hoses to prevent debris from
entering system during routing procedure.
Back to Top
