TB-9-2510-251-13

TECHNICAL BULLETIN

OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING

AUGUST 2007

TB-9-2510-251-13 - Page 99 of 624

2-83

TB 9-2510-251-13

2-1.3

Installation of Air Conditioning Kit to M1025 and M1025A1 with GSIE Add-on-Armor

(Cont’d).

b. Install Evaporator and Condenser

(1)

If present, remove plywood panel from between seats on top of transmission tunnel.

(2)

Remove top screws from driver’s side mats and transmission tunnel.

1

1

2

Figure 2-121.

Transmission Tunnel Holes

(3)

Position drill template (found in Installation Kit) on transmission tunnel and tape into

position.

Drill two 11/16 inch (.6875 inch) holes (1) and one 11/4 inch (1.25 inch) hole (2)

as shown on side of transmission tunnel.

(4)

De-burr panel.

(5)

Remove front passenger seat to expose battery box.

3

Figure 2-122.

Battery Box

(7)

Drill 3/4 inch hole in rear battery box panel near top inboard edge.

(8)

Install grommet (4).

4

Figure 2-123.

Battery Box Panel Hole

(6)

Remove either auxiliary power panel (3) or batteries to gain access to drill hole in battery

box.