TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 95 of 624
2-79
TB 9-2510-251-13
15
14
8
16
9
13
2-1.3
Installation of Air Conditioning Kit to M1025 and M1025A1 with GSIE Add-on-Armor
(Cont’d).
a. Install Compressor (Cont’d)
WARNING
Solvent used to clean parts is potentially dangerous to personnel and property.
Clean parts in a well-ventilated area.
Avoid inhalation of solvent fumes.
Wear
goggles and rubber gloves to protect eyes and skin.
Wash exposed skin
thoroughly.
DO NOT smoke or use near open flame or excessive heat.
Failure to
observe this warning could result in severe injury or death to personnel.
Figure 2-116.
Compressor Adjusting Arm
(8)
Clean mounting surface where mounting bracket mounts to engine with solvent
(item 10, Appendix D).
(9)
Lower mounting bracket (9) and compressor (8) onto mounting location in front left side of
engine.
(10)
Position compressor adjusting arm (13) on compressor (8) and secure with bolt (14),
washer (15), and locknut (16).
Tighten bolt (14) to 18 ft-lbs.
Do not overtighten.
Back to Top
