TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 71 of 624
2-55
TB 9-2510-251-13
2-1.2
Installation of Air Conditioning Kit to M1097A2 with GSIE Add-on-Armor (Cont’d).
b. Install Evaporator and Condenser (Cont’d)
23
23
23
22
Figure 2-83.
Install Evaporator Unit
(21)
Insert four new bolts (24), flat washers (25), and oversize washers (26) through lower
evaporator support bracket, armor plates, rear curtain and condenser mount angle.
Install
flat washers (27) and locknuts (28) and tighten snug.
28
27
25
26
24
Figure 2-84.
Lower Support Bracket
23
(17)
Remove two lower center 1/2 inch bolts from rear center armor plate and rear side armor
plates.
(18)
Hang evaporator unit (20) from inside top of armor plate (above holes drilled in
transmission tunnel).
(19)
Adjust evaporator unit (20) to align slots in lower support bracket (22) with slots in center
armor plate.
(20) Tighten evaporator unit top clamp bracket bolts (23).
Back to Top
