TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 79 of 624
2-63
TB 9-2510-251-13
2-1.2
Installation of Air Conditioning Kit to M1097A2 with GSIE Add-on-Armor (Cont’d).
d. Install Refrigerant Hoses (Cont’d)
#12 HOSE
#8 HOSE
Figure 2-97.
Refrigerant Hose Routing (#8 and #12)
(5)
Compressor to condenser:
a.
Four-door vehicles only, #8 hose
:
Route hose through grommet and forward along
frame rail.
Continue forward and outboard of parking brake linkage and up into engine
compartment near oil filter and dipstick.
b.
Two-door vehicles only, #8 hose:
Route hose through grommet and forward along
frame rail.
Continue forward and up into engine compartment near oil filter and dipstick.
(6)
Evaporator to compressor:
a.
Four-door vehicles only, #12 hose:
Route hose through grommet and forward along
frame rail.
Continue forward and outboard of parking brake linkage and up into engine
compartment near oil filter and dipstick.
b.
Two-door vehicles only, #12 hose:
Route hose through grommet and forward above
driveshaft.
Continue forward and up into engine compartment near oil filter and
dipstick.
(7)
Route both #8 and #12 hoses over engine and behind air intake duct to passenger side of
engine.
Continue forward to compressor.
CAUTION
•
Avoid high heat surfaces, sharp edges, and moving parts of vehicle.
Keep
hoses tucked up high enough to prevent being snagged as vehicle travels over
obstacles or brush.
Failure to comply may result in damage to equipment.
•
Hoses should span no more than two feet without being secured.
Failure to
comply may result in damage to equipment.
(8)
Secure #8 and #12 hoses under vehicle and along firewall.
Back to Top
