TB-9-2510-251-24
TECHNICAL BULLETIN
INSTALLATION, REMOVAL, AND PARTS INSTRUCTIONS FOR ADD ON ARMOR (AOA) AND ASSOCIATED COMPONENTS FOR HMMWV FAMILY OF VEHICLES (FOVs)
JULY 2005
TB-9-2510-251-24 - Page 48 of 212
TB 9-2510-251-24
1-38
3)
Install B-partition assemblies as follows (see figure 1-18).
a.
Align right B-partition assembly (10) and left B-partition assembly (2) into position with right and left B-
partition mount brackets.
Mark a line onto vehicle tunnel for B-partition rubber location.
b.
Clean vehicle tunnel in rubber strip application area with denatured alcohol.
c.
Apply rubber strip (9) to vehicle tunnel in location marked in previous step.
d.
Install right B-partition assembly (10) onto right B-partition mount bracket securing with two capscrews
(3), washers (4) and locking nuts (5).
Do not tighten capscrews (3) at this point.
e.
Install left B-partition assembly (2) onto right B-partition mount bracket securing with two capscrews (3),
washers (4) and locking nuts (5).
Do not tighten capscrews (3) at this point.
f.
Install seven capscrews (1), washers (7) and locking nuts (8) to secure left B-partition assembly (2) to
upper B-partition gap strip (11) and lower B-partition gap strip (6).
Torque all capscrews (1 and 3) to 37
lb ft (50 N
•
m).
g.
Torque eight B-partition mount bracket capscrews (2 from figure 1-16) to 21 lb ft (28N
•
m).
Back to Top
