TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 42 of 704
TB 9-3950-253-13&P
0006-2
0006
CONVERT SLIDER BEDS FROM FLATRACK TO CONTAINER CONFIGURATION
0006
Front Slider Bed Configuration
0006
NOTE
•
Front slider bed container configuration is the same for both PLS and HEMTT.
•
Rear twistlocks on HEMTT require adjustment for container configuration.
1. Position vehicle as if loading a flatrack (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
WARNING
•
During these adjustments, you are required to work at rear of vehicle where there are
several protruding parts. Use extreme caution and wear a hard hat.
•
Front slider bed is heavy. Use extreme caution while changing configuration of front roller
beds.
•
Failure to follow these warnings may result in injury to personnel.
NOTE
Perform steps 2 and 3 for both right and left sides.
2. From rear of vehicle, on left side, raise front slider bed (Figure 2, Item 1) slightly to relieve tension on locking
pin (Figure 2, Item 3).
3. Continue to pivot front slider bed (Figure 2, Item 1) until it aligns with rear slider bed (Figure 2, Item 2) and
locking pin engages into locked position.
Figure 2.
Front Slider Bed (Flatrack to Container).
06
3
1
2
2
1
Back to Top
