TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 41 of 704
0006-1
TB 9-3950-253-13&P
0006
OPERATOR MAINTENANCE
-
SLIDER BED CONFIGURATION
Introduction, Convert Slider Beds from Flatrack to Container Configuration,
Convert Slider Beds from Container to Flatrack Configuration
INTRODUCTION
0006
The rear slider assembly has two configurations: container and flatrack.
a. In container configuration, the front slider beds and twistlock assemblies are positioned to be on the same
horizontal plane as the rear slider beds.
b. In flatrack configuration, the front slider beds are at an angle to the rear slider beds and on the same
horizontal plane as the truck bed. On the HEMTT only, the rear twistlocks are folded under rear slider beds
to comply with departure angle requirements.
Figure 1.
Slider Bed Configurations.
06
INITIAL SETUP
References
0
TM 9-2320-326-14&P
0
TM 9-2320-364-14&P
0
Equipment Conditions
0
Hook arm in home position (PLS: TM 9-2320-
364-14&P, HEMTT: TM 9-2320-326-14&P)
0
MODE switch set to OFF position (PLS: TM 9-
2320-364-14&P, HEMTT: TM 9-2320-326-
14&P)
0
Equipment Conditions - Continued
0
Stowage switch set to OFF position (WP
0004)
0
NO TRANS light off (PLS: TM 9-2320-364-
14&P, HEMTT: TM 9-2320-326-14&P)
0
Vehicle in neutral gear with parking brake
applied
(PLS:
TM
9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P)
0
FLATRACK
FLATRACK CONFIGURATION
CONTAINER CONFIGURATION
PLS & HEMTT
CONFIGURATION PLS
HEMTT
6
Back to Top
