TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 44 of 704
TB 9-3950-253-13&P
0006-4
0006
CONVERT SLIDER BEDS FROM CONTAINER TO FLATRACK CONFIGURATION
0006
Front Slider Bed Configuration
0006
WARNING
•
During these adjustments, you are required to work at the rear of the vehicle where there
are several protruding parts. Use extreme caution and wear a hard hat.
•
Front slider bed is heavy. Use extreme caution while changing the configuration of front
slider beds.
•
After releasing locking pin, move hands out of the way to avoid pinching.
•
Failure to follow these warnings may result in injury to personnel.
1. From rear of vehicle, on left side, push front slider bed (Figure 4, Item 1) slightly to relieve tension on locking
pin (Figure 4, Item 2) and push down on locking pin, keeping it from engaging with front slider bed.
2. Allow front slider bed (Figure 4, Item 1) to pivot downward until it reaches a horizontal position and locking pin
(Figure 4, Item 2) engages into locked position.
Figure 4.
Front Slider Bed (Container to Flatrack).
06
1
1
2
Back to Top
