TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 26 of 127
TM 10-5411-205-13
Table 3-1. Troubleshooting.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
2.
3.
4.
5.
OUTER DOOR OR INNER DOOR DOES NOT OPEN OR CLOSE SMOOTHLY
Step 1.
Inspect hinges for adequate lubrication.
Lubricate as required (paragraph 3-1).
Step 2.
Adjust or repair door as necessary (paragraph 3-19).
OUTER DOOR OR INNER DOOR DOES NOT STAY OPEN
Step 1.
Check to see if detent pin is installed in door stay channel.
Install detent pin in channel.
Step 2.
Check to see if detent pin is missing.
Install detent pin on door (paragraph 3-32.f).
DOOR HANDLE IS JAMMED OR DOES NOT OPERATE SMOOTHLY
Step 1.
Inspect components for adequate lubrication.
Lubricate as required (paragraph 3-1).
step 2.
Inspect door handle and latching mechanism for missing or damage com-
ponents.
Repair or replace components as required (paragraph 3-19).
LOUVER COVER DOES NOT STAY OPEN
Step 1.
Check to see if holder assembly is attached to louver cover.
Attach holder assembly to louver cover.
Step 2.
Check to see if holder assembly is secure or damaged.
Repair or replace components as required (paragraph 3-24).
WATER IS GETTING INTO SHELTER
Step 1.
Check condition of weather gaskets around the inside edge of each door,
Replace deteriorated gaskets (paragraph 3-18).
3-9
Back to Top
