TM-10-5411-205-13

SHELTER, ELECTRICAL EQUIPMENT - 250/G

TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL

MAY 1995
CHANGE 2

  TM-10-5411-205-13 - Page 31 of 127

TM 10-5411-205-13
3-9. General Repair
(1) Installation.
Procedures (cont).
(Figure 3-6)
NOTE
When installing new rivet in same location as a rivet that has been
removed and if diameter of hole in structure has been enlarged
during removal of rivet, use next larger diameter rivet for
replacement.
Clean rivets with solvent before installing.
PROPER INSTALLATION
IMPROPER INSTALLATION
Figure 3-6. Installing Blind Rivets.
(a)
Determine type, size and grip range of rivet to be used. Grip length
equals combined thickness of materials being riveted together. Grip range
of rivet must encompass grip length.
Drilling creates metal chips which may enter eyes and cause seri-
ous injury. Eye protection is required.
CAUTION
Do not drill deeper than necessary to
through other side of panel.
NOTE
install rivet as you may drill
Drill hole size must match size of rivet being used.
Quantities of sheets maybe drilled at the same time when held
together with sheet fasteners.
3-14


Back to Top