TM-5-2350-377-13-P

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER

JUNE 2012

TM-5-2350-377-13-P - Page 149 of 404

FIELD MAINTENANCE

HEADLIGHT ASSEMBLY REPLACEMENT

INITIAL SETUP:

Tools and Special Tools

Tool Kit, General Mechanic's: Automotive

(WP

0071, Table 1, Item 7)

Wrench, Torque, Click, Ratcheting, 3/8 in. Drive

(75 ft-lb) (WP

0071, Table 1, Item 13)

Personnel Required

Construction Equipment Repairer, 91L

Equipment Condition

Front of vehicle blocked (TM 5-2350-262-20)

Equipment Condition (cont.)

Hydraulic pressure relieved (TM 5-2350-262-20)

Negative battery cables disconnected

(TM 5-2350-262-20)

REMOVAL

CAUTION

Do not turn or twist headlight during installation. Turning or twisting headlight can damage

headlight wiring harness.

NOTE

Installation procedures for the headlight are the same for both sides of the vehicle. The right

side is shown here.

1.

Remove four bolts (Figure 1, Item 2), washers (Figure 1, Item 3), and flat washers (Figure 1, Item 4) from

headlight (Figure 1, Item 1) and apron (Figure 1, Item 5).

2.

Carefully lift headlight (Figure 1, Item 1) a few inches from apron (Figure 1, Item 5) to get at connector

(Figure 1, Item 6).

3.

Disconnect connector (Figure 1, Item 6) and pull away from headlight (Figure 1, Item 1).

3

1

M0003HBF

2

4

5

6

Figure 1.

Headlight Removal.

END OF TASK

TM 5-2350-377-13&P

0030

0030-1