TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 763 of 894

TRUCK SERVICE MANUAL

TRANSMISSION

INSPECTION AND REBUILD

Fig. 6-13 Fourth clutch assembly-cross-section view

step will not (fig. 6-44). The prescribed clearance is 0.

080 to 0.120 inch(2.03 to 3.05 mm). Any clearance

measurement within this range is satisfactory, but the

nearer to 0. 080 inch that can be attained, the longer the

clutch will maintain satisfactory clearance.

(8) Install 20 piston release springs, one each on

the 20 cast bosses on the fourth clutch piston (fig. 6-40).

(9) Install the spring retainer, recessed side

(outer lip) down, on the 20 piston return springs (fig. 6-

40).

(10) Compress the spring retainer until the

snapring groove on the clutch hub is clear (fig. 6-41).

Install the snapring.

(11) Grease (with oil-soluble grease) and install

the bearing race onto the rear hub of the fourth-clutch

housing (fig. 6-39).

(12) Grease (with oil-soluble grease) and install

the bearing race onto the front hub of the fourth-clutch

housing assembly (fig. 6-38).

6-19. CENTER SUPPORT ASSEMBLY

a.

Disassembly

(A,

foldout

12)