TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 42 of 694
TM 5-3895-372-20
(4)
Electric wires and connectors:
Look for cracked or broken insulation, bare wires, and loose or broken
connectors.
Tighten loose connections and make sure the wires are in good condition.
(5)
Hoses and fluid lines
: Look for wear, damage, and leaks.
Make sure clamps and fittings are tight.
Wet
spots show leaks, of course, but a stain around a fitting or connector can mean a leak.
If a leak comes from a loose fitting
or connector, tighten it.
If something is broken or worn out, either correct it or report it to direct support (refer to MAC
chart).
e.
It is necessary for you to know how fluid leaks affect the status of your equipment.
The following are
definitions of the types/classes of leakage you need to know to be able to determine the status of your equipment.
Learn
and be familiar with them and REMEMBER - When in doubt, notify your supervisor!
Leakage definitions for Organizational PMCS:
CLASS I
Seepage of fluid (as indicated by wetness or discoloration) not great enough to form drops.
CLASS II
Leakage of fluid great enough to form drops but not enough to cause drops to drip from the item being
checked/inspected.
CLASS III
Leakage of fluid great enough to form drops that fall from the item being checked/ inspected.
3-4
Back to Top
