TM-5-5420-202-20-2
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4
OCTOBER 1985
TM-5-5420-202-20-2 - Page 440 of 734
TM 5-5420-202-20-2
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 4 of 7)
14.
15.
16.
17.
18.
NOTE
It may be necessary to use
hammer and punch to unseat
sensors (Q and R) by tapping
upward on the edge of the
sensor retaining nut.
Using 1/2 inch socket and extension, loosen
capscrew (N) to provide movement to fuel-
water separator filter (C).
Using 9/16 inch wrench, remove upper sensor (P)
from fuel-water separator filter (C).
Tag upper sensor (P) to make sure of correct
installation.
Using 9/16 inch wrench, remove lower sensor (Q)
from fuel-water separator filter (C).
Tag lower sensor (Q) to make sure of correct
installation.
12. Using 1/2 inch socket and extension, remove
three capscrews, lockwashers, and washers (L).
13. Remove clamp (M) from filter (C).
Go on to Sheet 5
7-205
Back to Top
