TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 447 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (Sheet 4 of 5)

INSTALLATION:

1. Install three clamps (A) onto sensor leads from replaced fuel-water

separator control assembly (B).

2. Position fuel-water separator control

assembly (B) onto mounting plate.

3. Using 5/16 inch wrench, install

three screws and washers (C).

4. Using 5/16 inch wrench, install screw (D)

and cushioned clamp (A) holding solenoid

valve electrical lead (E) to fuel-water

separator control assembly (B).

5.

6.

Be careful not to strike

ends of sensors during installa-

tion or damage may result.

NOTE

Straight edge of mounting

plate (F) must be installed

to the right against the fuel

water separator.

Manually connect solenoid valve elec-

trical lead (E) to fuel-water separator

control assembly (B).

Manually connect engine electrical

harness connector (G) to fuel-water

separator control assembly (B).

7. Using screwdriver, install two screws

(H), two cushioned clamps (A), and mounting

plate (F) at right side and above fuel-

water separator control assembly.

Go on to Sheet 5

7-212