TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 443 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 7 of 7)

13.

Using lint-free cloth, wipe bottom of fuel-

water separator filter and connecting lines

clean of fuel.

14.

Remove drip pan.

TEST:

1.

Connect engine for powerplant ground hop (page

2.

Using 1/2 inch wrench, open bleed valve (A).

3.

Set FUEL PUMPS switch on master control

panel to ON (TM 5-5420-202-10).

4.

Set MASTER BATTERY switch on master

control panel to ON (TM 5-5420-202-10).

Watch bleed cap (A) of fuel-water separator

5.

6.

7.

8.

9.

10.

11.

12.

filter (B) for air release (bubbles).

Set MASTER BATTERY switch to OFF

(TM 5-5420-202-10). When constant fuel

flow is seen, go to step 6.

Using 1/2 inch wrench, turn fuel-water

separator bleed cap (A) clockwise until

snug.

Check valve for leaks and tighten or replace components as necessary.

Perform operational check of automatic drain (page 7-245).

Set FUEL PUMPS switch to OFF (TM 5-5420-202-10).

Set MASTER BATTERY switch to OFF (TM 5-5420-202-10).

Disconnect engine from powerplant ground hop (page 5-40).

Install powerplant (page 5-14).

End of Task

7-208