TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 442 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 6 of 7)

8.

9.

10.

11.

Using 9/16 inch wrench, install condensate

drain line (J) to elbow (K).

Remove plastic barrier material and tape

from openings of fuel inlet line (L) and

elbow (M).

Using 7/8 inch wrench, install fuel line (L)

to elbow (M).

Remove plastic barrier material and tape from

openings of fuel outlet line (N), smoke generator

line (P), and tee (Q).

Using 7/8 inch wrench, install outlet line (N)

and smoke generator line (P) to tee (Q).

12.

5.

Using 1/2 inch socket and extension, install

two capscrews, lockwashers, and washers (E).

6.

Position clamp (F) around sensor wires (C)

and (D) and, using 1/2 inch socket, install

capscrew, lockwasher, and washer (G) and

clamp (F) onto fuel-water separator filter (H).

7.

Using 1/2 inch socket, tighten capscrews (B)

(G) and (E).

Go on to Sheet 7

7-207