TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 448 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (Sheet 5 of 5)

8.

9.

10.

11.

TEST:

1.

2.

Connect engine for powerplant ground hop

(page 5-25).

Set FUEL PUMPS switch in ON position

(TM 5-5420-202-10).

3.

4.

5.

6.

7.

8.

9.

10.

11.

Using 9/16 inch wrench, install lower

(longer) sensor (J) to fuel-water separator

filter .

Using 9/16 inch wrench, install upper

(shorter) sensor (K) to fuel-water separator

filter .

Using 1/2 inch socket and extension, install

three capscrews, lockwashers, and washers (L)

and clamp (M).

Using 1/2 inch socket, tighten capscrew (N).

Set MASTER BATTERY switch to ON position

(TM 5-5420-202-10). Watch fuel-water

separator bleed cap (A) for air release (bubbles).

Set MASTER BATTERY switch to OFF position

(TM 5-5420-202-10). After about 1 minute,

repeat step 3.

Check for leaks and tighten or replace components as necessary.

Using 7/16 inch wrench, turn fuel-water separator bleed valve (A) clockwise until snug.

Perform operational check of automatic drain (page 7-223).

Set FUEL PUMPS switch to OFF position (TM 5-5420-202-10).

Set MASTER BATTERY switch to OFF position (TM 5-5420-202-10).

Disconnect engine from powerplant ground hop (page 5-40).

Install powerplant (page 5-14).

End of Task

7-213