TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 446 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (Sheet 3 of 5)

12.

Using screwdriver, remove two screws

and two cushioned clamps (J) and mount-

ing plate (K) at right side and above

fuel-water separator control assembly (L)

NOTE

It may be necessary to use

pliers to start removal of con-

nectors in steps 13 and 14.

13. Manually disconnect engine electrical

harness connector (M) from fuel-water

separator control assembly (L) l

14. Manually disconnect solenoid valve

electrical lead (N) from fuel-water

separator control assembly (L).

15.

16.

Using 5/16 inch wrench, remove screw

and cushioned clamp (P) holding

solenoid valve electrical lead (N)

to fuel-water separator control

assembly (L).

Using 5/16 inch wrench, remove three

remaining screws and washers (Q)

holding fuel-water separator control

assembly (L) to mounting plate.

Remove control assembly.

Go on to Sheet 4

7-211