TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

  TM-5-5420-202-20-3 - Page 584 of 1060

TM 5-5420-202-20-3
THRUST WASHER BEARING SEAL (OUTPUT FLANGE) (SHEET 2 of 2)
INSTALLATION:
1. Lubricate oil seal (A) with
high-temperature grease.
2. Using hammer and
wooden block, tap seal (A)
into place.
3. Using brass drift,
insure seal (A) is seated
to the bottom of bore (B).
4. Aline -o- mark on
output flange (C) with -o-
mark on output shaft (D)
and install flange (C) on
shaft (D) to nearest spline.
5. Install washer (E) and
screw (F) on output shaft
(D).
Using socket and
torque wrench, tighten
screw (F) to 150 - 200 ft-
lbs(203-271
N·m).
6. Using pliers, install
nonelectrical wire (G) to
secure screw (F) to flange (C)
and trim excess.
End of Task
Change 2
11-86.1


Back to Top