TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 575 of 1060

TM 5-5420-202-20-3

SHIFT LINKAGE ADJUSTMENT (Sheet 27 of 28)

142.

143.

144.

145.

146.

147.

RIGHT REAR OF VEHICLE

Using 9/16 inch wrench, adjust shifting

rod bearing end (BY) by turning clockwise

or counterclockwise until screw (BZ) will

drop freely through clevis (AN) and shifting

rod bearing end (BY).

Using 9/16 inch wrench, install screw (BZ)

through clevis (AN) and shifting rod bearing

end (BY).

Holding rod bearing end (BY) with 9/16 inch wrench, use torque wrench and 9/16 inch

crowfoot adapter to tighten jamnut (BU) to 16-18 lb-ft (22-24 N·m).

Remove locating pin from alinement hole (C).

Using torque wrench and 9/16 inch socket, tighten screw (BZ) to 16-18 lb-ft (22-24 N·m)

and go to step 156.

Using 9/16 inch wrench, remove screw (BZ) and remove shifting rod bearing end (BY) from

clevis (AN).

148.

149.

150.

151.

Go on to Sheet 28

11-78

Using 9/16 inch wrench, adjust shifting rod bearing end (BY) by turning clockwise until

shifting rod (BV) is past hole (BX).

Using 9/16 inch wrench, install screw (BZ) through clevis (AN) and shifting rod bearing end

(BY).

Holding rod bearing end (BY) with 9/16 inch wrench, use torque wrench and 9/16 inch

crowfoot adapter to tighten jamnut (BU) to 16-18 lb-ft (22-24 N·m).

Using torque wrench and 9/16 inch socket, tighten screw (BZ) to 16-18 lb-ft (22-24 N·m).

TA249344