TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 17 of 28)
NOTE
Do not allow shifting rod (BB) to
step 87. Shifting rod (BB) is made
one piece and may come apart if
turn while doing
up of more than
allowed to turn.
87.
Using 9/16 inch wrench, adjust shifting rod
bearing end (BF) by turning clockwise or
counterclockwise until screw (BG) will drop
freely through clevis (BH) and shifting rod
bearing end (BF).
FORWARD OUTBOARD
LINK ASSEMBLY
RIGHT REAR OF
ENGINE COMPARTMENT
88.
89.
90.
91.
Go on to Sheet 18
11-68
Using 9/16 inch wrench, install screw (BG).
Holding rod bearing end (BF) with 9/16 inch
wrench, use torque wrench and 9/16 inch crow-
foot adapter to tighten jamnut (AY) to 16-18
lb-ft (22-24 N·m).
Remove locating pin (AU) from alinement
holes.
Using torque wrench and 9/16 inch socket,
tighten screw (BG) to 16-18 lb-ft (22-24 N·m)
and go on to step 103.
TA249334