TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 556 of 1060

TM 5-5420-202-20-3

SHIFT LINKAGE ADJUSTMENT (Sheet 8 of 28)

29.

30.

31.

32.

33.

34.

35.

36.

37.

38.

Using 9/16 inch wrench, remove screw (Y) and

remove shifting rod bearing end (X) from

clevis (Z).

Using 9/16 inch wrench, adjust shifting rod

bearing end (X) clockwise until shifting rod

(S) is past hole (V).

Using 9/16 inch wrench, install screw (Y) through clevis (Z) and shifting rod bearing

end (X).

Holding rod bearing end (X) with 9/16 inch wrench, use torque wrench and 9/16 inch

crow foot adapter to tighten jamnut (P) to 16-18 lb-ft (22-24 N·m).

Using torque wrench and 9/16 inch socket, tighten screw (Y) to 16-18 lb-ft (22-24 N·m).

Using 9/16 inch wrench, adjust shifting rod bearing end (T) by turning clockwise or counter-

clockwise until screw (R) will slide freely through clevis (U) and shifting rod bearing

end (T).

Using 9/16 inch wrench, install screw (R) through clevis (U) and shifting rod bearing

end (T).

Holding rod bearing end (T) with 9/16 inch wrench, use torque wrench and 9/16 inch

crow foot adapter to tighten jamnut (Q) to 16-18 lb-ft (22-24 N·m).

Remove locating pin (L) from alinement holes.

Using torque wrench and 9/16 inch socket, tighten screw (R) to 16-18 lb-ft (22-24 N·m).

Go on to Sheet 9

TA249325

11-59