TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

  TM-5-5420-202-20-3 - Page 573 of 1060

TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 25 of 28)
132.
TOP OF TRANSMISSION
Using small diameter wire, check to see if
shifting rod (BV) is past holes (BW) and
(BX). If shifting rod (BV) is past holes
(BW) and (BX), do steps 133 thru 136. If
shifting rod (BV) is not past hole (BW),
do steps 137 thru 146. If shifting rod (BV)
is not past hole (BX), go on to step 147.
133.
134.
RIGHT REAR OF VEHICLE
135.
Remove locating pin from alinement
136.
Using torque wrench and 9/16 inch
and go to step 156.
Go on to Sheet 26
Using 9/16 inch wrench, install screw (F)
through clevis (H) and shifting rod bearing
end (G).
Holding rod bearing ends (G) and (BY) with
9/16 inch wrench, use torque wrench and
9/16 inch crowfoot adapter to tighten jamnuts
(BT) and (BU) to 16-18 lb-ft (22-24 N·m).
hole (C).
socket, tighten screw (F) to 16-18 lb-ft (22-24 N·m)
TA249342
11-76


Back to Top