TM 5-5420-202-20-3
SERVOBANDS ADJUSTMENT (Sheet 1 of 3)
TOOLS: Torque wrench with 1/2 in. drive (0 to 175 lb-ft) (0 to 237 N·m)
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1-1/16 in. socket with 1/2 in. drive
1-1/16 in. open end wrench
SPECIAL TOOLS:
Socket wrench socket (Item 6, Chapter 3, Section I)
SUPPLIES: Self-locking bolt
REFERENCE:
TM 5-5420-202-10
PRELIMINARY PROCEDURES:
Set shift lever in “P” park position (TM 5-5420-202-10)
Remove transmission shroud (page 9-2)
Procedures are the same for adjustment of both the low and
reverse bands.
1.
Using 9/16 inch socket, remove self-locking
bolt (A) and washer (B) holding lock plate (C).
Remove lock plate (C). Throw self-locking bolt
(A) away.
Go on to Sheet 2
Change 4
11-83