TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 815 of 1060

TM 5-5420-202-20-3

SUSPENSION TORSION BAR

REPLACEMENT (Sheet 3 of 7)

8.

Using crowbar (or pinch bar), apply upward

force to bottom of roadwheel arm (E).

NOTE

Adapter must be tightened after

each striking movement.

12. Using slide hammer puller with adapter,

strike torsion bar (F) with slide hammer

by sliding slide hammer puller along slide

hammer rod.

13. Keep on striking torsion bar (F) with slide

hammer. Hammer with some force until

torsion bar (F) spline is free from side of hull.

14.

Pull bar (F) out of support arm (E).

Go on to Sheet 4

14-26

Change 4