TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 817 of 1060
TM 5-5420-202-20-3
SUSPENSION TORSION BAR REPLACEMENT (Sheet 5 of 7)
1.
Apply grease to splined ends of torsion bar (A).
2.
Fill outer end opening with
deep).
grease (1/4-inch
3.
Insert unmarked end of bar (A) into roadwheel
support arm (B) housing.
4.
Rotate torsion bar (A) so that index mark is at
top.
5.
Push bar (A) through housing until inside
end enters anchor on other side of vehicle.
When this is done, about 1/2 inch of bar
will be out of housing.
Go on to Sheet 6
14-28
Change 4
Back to Top
