TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

  TM-5-5420-202-20-3 - Page 821 of 1060

TM 5-5420-202-20-3
TORSION BAR ANCHOR REPLACEMENT (Sheet 2 of 3)
NOTE
If anchor cannot be removed,
perform steps 4 thru 9. If anchor
was removed, go to step 10.
4.
5.
6.
7.
8.
9.
Using socket head screw key, remove
two plugs (G) from cover (C).
Reverse cover (C) and secure to anchor
(F) using two previously removed screws
(A).
NOTE
Cover (C) will rest against road-
wheel housing (H).
Using socket, alternately tighten screws
(A) until snug.
WARNING
Hold cover (C) in place while
performing step 7. Cover (C) and
anchor (F) could fall free from
vehicle, causing injury.
Alternately tighten screws (A) to pull
anchor (F) from vehicle evenly.
Remove cover (C) and anchor (F) from
vehicle.
Remove two screws (A) securing cover
(C) to anchor (F).
Go on to Sheet 3
14-32
Change 4
10.
11.
12.
Separate anchor (F) from cover (C).
If pins (J) must be removed from cover,
using drill, make 1/4 inch hole in top of
pin.
Using extractor tool, remove pins (J)
from cover.


Back to Top