TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 822 of 1060

TM 5-5420-202-20-3

TORSION BAR ANCHOR REPLACEMENT (Sheet 3 of 3)

13. Apply corrosion preventive to the inside of the

torsion bar anchor housing and solid film

lubricant to the torsion bar anchor.

14. Remove them, as necessary, to repair

suspension system.

INSTALLATION:

1.

Press two pins (A) into cover (B), if they were

removed.

2.

Install gasket (C) to cover (B).

3.

Position anchor (D) onto cover (B) so that two

pins (A) fit into holes in anchor.

4.

Lift cover (B) and anchor (D) as an assembly.

Mount in roadwheel housing (E) opening.

5.

Install four new lockwashers (F) and screws (G)

to secure cover (B) to housing (E).

6.

Using socket wrench, tighten four screws (G).

7.

Install torsion bar at opposite side of tank (page

14-27).

End of Task

Change 4

14-33