TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

  TM-9-2320-209-20-3-1 - Page 722 of 830

TM 9-2320-209-20-3-1
NOTE
Be very careful not to move shifting lever (1) from the
position set in frame 4.
1.
Pull shifter shaft (2) out to engage low speed gears. Check that detent action
holds shaft in this position.
2.
Check if holes in yoke (3) aline with hole in shifter shaft (2). If holes do not
aline, adjust length of rod (4) by screwing yoke (3) onto rod (4) to shorten
rod length or unscrewing yoke (3) from rod (4) to make rod longer.
3.
When holes in yoke (3) aline with hole in shifter shaft (2), put in shoulder
bolt (5) as shown. Screw on locknut (6) and tighten using 3/4-inch wrenches.
GO TO FRAME 6
9-12


Back to Top