TM-9-2320-209-20-3-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 3 OF 4

MAY 1981

TM-9-2320-209-20-3-3 - Page 186 of 548

TM

9-2320-209-20-3-3

FRAME 2

Soldier A 1.

Soldier B 2.

Soldier A 3.

Soldier B 4.

5.

6.

Soldier A 7.

Soldier B 8.

END OF TASK

Hold yoke (1) with one hole up and the other down.

Put spider (2) in yoke (1) by first putting one end down into

hole where bearing (3) goes. The other end can now be put in.

Hold spider (2) up into top hole as far as it will go.

Put bearing (4) on end of spider (2). Press bearing into yoke (1).

Put brass punch on bearing (4). Using hammer, drive bearing

into yoke (1).

Using retaining ring pliers, put retaining ring (5) into yoke (1).

Hold spider (2) in bearing (4) and turn yoke (1) over. Lift spider

about halfway out of bearing.

Do steps 4, 5, and 6 again for bearing (3).

NOTE

Follow-on Maintenance Action Required:

Replace drive shaft in truck. Refer to para 18-59.

18-171