TM-9-2320-209-20-3-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 3 OF 4

MAY 1981

  TM-9-2320-209-20-3-3 - Page 183 of 548

TM 9-2320-209-20-3-3
FRAME 2
Soldier A 1. Hold yoke (1) on wood block as shown.
NOTE
Drive pin punch must be a little smaller than end of
journal (2) so punch can go through bore of bearing.
Soldier B 2. Using hammer and drive pin punch, hammer end of journal (2)
down into yoke (1). Bearing (3) will come out at bottom of yoke.
Soldier A 3. Turn yoke (1) over.
Soldier B 4. Do step 2 again for other bearing (3). When bearing falls out, take
spider (4) out of yoke (1) by letting one end down into hole
where bearing was. Take out other end first.
GO TO FRAME 3
18-168


Back to Top