TM-9-2320-209-20-3-3
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 3 OF 4
MAY 1981
TM-9-2320-209-20-3-3 - Page 185 of 548
TM
9-2320-209-20-3-3
c.
Replacement.
FRAME 1
Soldier A
Soldier B
Soldier A
Soldier B
Soldier A
Soldier B
Soldier A
1.
2.
3.
4.
5.
6.
7.
8.
9.
GO TO FRAME
Take grease and work it in on rollers inside bearing (1). Do this
to four bearings that will be used.
Hold yoke (2) with one hole up and the other down.
Put spider (3) in yoke (2) by first putting one end down into hole
where bearing (4) goes. The other end can now be put in.
Hold spider (3) up into top hole as far as it will go.
Put bearing (1) on end of spider (3). Press bearing into yoke (2).
Put brass punch on bearing (1). Using hammer, drive bearing
into yoke (2).
Using retaining ring pliers, put retaining ring (5) into yoke (2).
Hold spider (3) in bearing (1) and turn yoke (2) over. Lift
spider (3) about halfway out of bearing.
Do steps 5, 6, and 7 again for bearing (4).
2
18-170
Back to Top
