TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 156 of 592

TM 9-2320-209-34-2-3

FRAME 33

1.

2.

3.

4.

5.

6.

7.

8.

9.

Place seal (1) in groove of bearing retainer (2).

If retaining rings (3) were taken out of idler pulley (4), put on retaining

rings.

If bearing cups (5) were taken out, press new cups into idler pulley (4).

Pack tapered roller bearings (6) with type GAA, MIL-G-10924 automotive

grease.

Put bearings (6) into bearing cups (5).

Place idler pulley (4) on pulley shaft (7).

Place seal (1) in groove of bearing retainer (8).

Place bearing retainer and nut (8) on pulley shaft (7). Tighten nut so

pulley turns without end play in bearing.

Put on cotter pin (9).

NOTE

Idler pulley and bracket assembly will be installed

during follow-on tasks.

END OF TASK

18-145