TM-9-2320-272-23-4
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 4 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-4 - Page 997 of 1393
INSTALLATION
1.
Install o-ring (Figure 5, Item 5) sideways in filter housing (Figure 5, Item 4). Rotate and seat into position when
o-ring contacts rear of filter housing.
WARNING
Hydraulic filter assembly is under great pressure and oil will spurt out from housing during
installation. Wear eyeshields during installation of assembly. Failure to comply may result in
injury or death to personnel.
CAUTION
•
Indicator must be level and on right side of housing during installation. Assembly will not
seat if indicator is improperly positioned.
•
Do not reuse hydraulic oil from drainage container. Damage to equipment may result if
drain oil is used.
NOTE
•
Mechanic must seat filter assembly quickly and hold in place while assistant
installs
screws.
•
Have drainage container ready to catch oil.
•
Use drain pans to retain leaking/draining fluids. Refer to local procedures and plans for
preventing and responding to fluid spills or leaks. Comply with local regulations when
disposing of clean up material and leaked and spilled fluids.
2.
Position filter cover (Figure 5, Item 1) with filter assembly (Figure 5, Item 2) just inside filter housing
(Figure
5,
Item
4).
3.
Push filter cover (Figure 5, Item 1) quickly into filter housing (Figure 5, Item 4) and install with four screws
(Figure 5, Item 3).
3
4
5
M9825DAA
4
1
2
4
1
Figure 5.
Crane Hydraulic Filter.
TM 9-2320-272-23-4
0707
0707-8
Back to Top
