TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 103 of 400
0018-1
TM 9-2320-283-13&P
0018
FIELD MAINTENANCE
ABS KIT INSTALLATION
Tools and Special Tools
General mechanic tool set (WP 0063, Table 2, Item 8)
Shop tools (WP 0063, Table 2, Item 9)
11/16 in. reamer (WP 0063, Table 2, Item 10)
Seal installer (WP 0063, Table 2, Items 3 through 7)
4-1/8 in. socket (WP 0063, Table 2, Item 1)
2-1/4 in. socket (WP 0063, Table 2, Item 2)
5/16 in. Drill bit (WP 0063, Table 2, Item 11)
Materials/Parts
Grease (WP 0066, Item 8)
Electrical tape (WP 0066, Item 9)
Sealing compound (WP 0066, Item 5)
Sealing compound (WP 0066, Item 6)
KIT # 000-008-19-25 (WP 0014, Table 1)
KIT # 001AFB (WP 0014, Table 2)
KIT # 002HDW (WP 0014, Table 3)
16 locknuts (WP 0056, Item 4)
Personnel Required
Assistant
References
TM 9-2320-283-10
TM 9-2320-283-20
Equipment Condition
Vehicle parked on hard level surface.
Parking brake set (TM 9-2320-283-10).
Battery power disconnected (TM 9-2320-283-20-2).
Mud flaps removed (TM 9-2320-283-10).
Blackout tail lamps and brackets removed
(TM 9-2320-283-20).
Stop/tail lamp and brackets removed
(TM 9-2320-283-20).
Trailer receptacle removed (TM 9-2320-283-20).
Hood raised and secured (TM 9-2320-283-10).
CAUTION
Ensure all tools required to install ABS kit are acquisitioned and used
during installation. Failure to use proper tools may result in damage
to equipment.
NOTE
Where applicable, ABS kit items called out within text and
illustrations are identified by their part number adjacent to the
corresponding callout number in the illustration. All existing
components/parts to be reused during installation of the ABS kit shall
be cleaned and inspected prior to installation IAW TM 9-2320-283-20.
GENERAL
The ABS installation consists of three separate kits: KIT # 000-008-19-25, KIT # 001AFB, and KIT # 002HDW.
Prior to installation, refer to WP 0014 ABS Kit Matrix and identify and inventory all parts contained in each kit.
REMOVING WHEELS
WARNING
Ensure wheel chocks are placed in front of tires opposite the end of
tractor to be raised and parking brake is released. If tractor is not free
to roll toward jack during jacking operations, tractor may topple jack.
Failure to comply may result in injury or death to personnel. Seek
medical attention in the event of an injury.
INITIAL SETUP:
Back to Top
