TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 219 of 1390

TM 9-2320-328-13&P-2

0126-5/(6 blank)

DRAFT

0126

Change 1

END OF TASK

FOLLOW-ON MAINTENANCE

Remove wheel chocks (TM 9-2320-422-10)

END OF TASK

END OF WORK PACKAGE

.

.

.

.

.

.

.

.

.

.

HWT3334

.

WARNING

.

ICON 3

.

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment, or

severe burns or electrical shock to personnel.

.

Step 4.

Remove SHORELINE INLET receptacle from pump house panel A (WP 0339).

Remove four screws from SHORELINE INLET receptacle. Remove back plate from

SHORELINE INLET receptacle.

Disconnect SHORELINE INLET receptacle 24 VDC

solenoid connectors.

While an assistant puts ENGINE switch to START position

(TM 9-2320-422-10), check for 22 to 28 VDC between SHORELINE INLET receptacle

solenoid from terminal connector to terminal connector while engine is being cranked.

.

a.

If 22 to 28 VDC are present, replace SHORELINE INLET

receptacle (WP 0268).

.

b.

If 22 to 28 VDC are not present, repair wires from SHORELINE INLET

receptacle to HEMTT starter if repairable (TM 9-2320-325-14&P), or

replace SHORELINE INLET receptacle (WP 0268).

.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION