TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 195 of 764
M764
TM 9-2320-361-34
7-4. REAR WIRING HARNESS Replacement (Contd)
I
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
7-44
NOTE
. Perform steps 3 through 6 for M764 vehicles.
●
Steps 3 through
6
cover
the
left
side
composite
light extensions.
Install two sets of extension wires (29) on each rear composite light bracket (8), bracket (19), tail
frame (27), and subframe (4) with six clamps (1), screws (18), and five new locknuts (9).
Connect wires (10), (11), (12), and (13) to rear composite light wires (17), (16), (15), and (14).
Connect wires (2), (3), (5), and (6) to wiring harness wires (22), (21), (20), and (7).
Install clamp (26) on rear wiring harness (25) and brace (24) with screw (23) and new locknut (28).
Repeat steps 3 through 6 for M764 right side composite light extensions.
NOTE
●
Perform
steps
8
and
9
for M275A2 vehicles.
●
Steps
8
and
9
cover
the
left
rear
composite
lights.
Connect wires (35), (36), (37), and (38) to rear composite light wires (31), (30), (40), and (39).
Install clamp (33) on rear wiring harness (25) and stud (34) with nut (32).
Repeat steps 8 and 9 for M275A2 right rear composite lights.
Install receptacle (41) and cap (54) on bracket (57) with four screws (55), ground wire (42), new
lockwasher (48), and four new locknuts (47).
Remove slack from rear wiring harness (25) and install five clamps (44) on rear wiring harness (25),
stud (49), and lefl side frame (45) with four screws (46), new locknuts (43), and nut (50).
Install rear wiring harness (25) on tail frame (53) with two clamps (52), screws (56), and new
locknuts (51).
Back to Top
