TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 189 of 764

M756A2

M756A2

TM 9-2320-361-34

7-4. REAR WIRING HARNESS REPLACEMENT (Contd)

14.

15.

16.

17.

18.

19.

20.

21.

22.

23.

NOTE

Perform steps

14

through 17 for M756A2 vehicles.

Disconnect

wires

(2)

and

(1)

from

front

clearance light wires (3) and (4).

Remove locknut (9), screw (7), and clamp (8) from rear wiring harness (6) and frame (5). Discard

locknut (9).

Disconnect wires

(16)

and

(12)

from rear clearance light wires (10) and (11).

Remove locknut (15), screw (13), and clamp (14) from subframe (17) and rear wiring harness (6).

Discard locknut

(15).

NOTE

Steps

18

and

19

cover left side composite light.

Disconnect wires (25), (26), (27), and (28) from composite light wires (24), (23), (22), and (21).

Remove locknut (29), screw (19), and clamp (18) from bracket (20) and rear wiring harness (6).

Discard locknut (29).

Repeat steps

18

and

19

for right side composite light.

NOTE

All trailer receptacles are removed basically the same.

Remove four locknuts

(45),

lockwasher

(44),

ground wire (31), four screws

(41), cap (40), and

receptacle (3o) from bracket

(43).

Discard locknuts

(45)

and lockwasher (44).

Remove two locknuts (37), screws (42), and clamps (38) from tail frame (39) and rear wiring harness (7).

Discard locknuts (37).

Remove four locknuts (32). screws (34), nut (36), and five clamps (33) from frame (5), stud (35), and

rear wiring harness (7). Discard locknuts (32).

7-38