TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 1109 of 1616

TM 9-2320-440-13&P

0156-3

0156

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

NOTE

•

Both height control links are disconnected from height control valve the same way. Right

side height control valve shown.

•

Note position of washers prior to removal to ensure proper installation.

6.

Remove locknut (5), washer (6), washer (7), screw (8), and height control link (9) from height control valve

(10). Discard locknut.

7.

Push down control arm of height control valve (10) to drain air pressure from suspension air spring (11).

8.

Repeat steps (6) and (7) to drain air pressure from left side suspension.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

NOTE

Each suspension air spring is secured to transverse beam with one nut and lockwasher.

9.

Remove two nuts (12) and lockwashers (13) from suspension air springs (11). Discard lockwashers.

10. Bend lock tab of two washers (14) away from nuts (15).

NOTE

Note position of spacers prior to removal to ensure proper installation.

11. Remove two nuts (15), washers (14), and spacers (16) from equalizing beams (17).

WARNING

Transverse beam is heavy (Aprox. 105 lbs). Do not lift transverse beam without the aid of Soldier B.

Failure to comply may result in injury to personnel.

12. Soldier A and Soldier B remove transverse beam (18) from two equalizing beams (17).

13. Remove two washers (19) from equalizing beams (17).

END OF TASK

THAAD0119