TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 205 of 1616

TM 9-2320-440-13&P

0024-3

0024

NO HIGH IDLE DURING MRP ELEVATION OPERATION OVER 5 DEGREES (CONTINUED)

THAAD0536

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

Step 2.

Retract deck elevation cylinders to the stowed position (WP 0007). Shut off engine

(

Open left engine cover (

Disconnect engine

harness connector MC20. Turn engine start switch ON (

Select N

(neutral) on transmission range selector (

Position LHS cab control

mode select switch to MRP position (WP 0007). With jumperwires installed in THAAD

chassis harness MUJB connector per Step 1, check for continuity from wire 451 at

engine harness connector MC20, terminal E1 to a known good ground, when MRP

palm button is pressed and deck elevation controls are operated (WP 0007).

If there is continuity, replace ECM (TM 9-2320-325-14&P).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION