TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 210 of 1616
TM 9-2320-440-13&P
0024-8
0024
NO HIGH IDLE DURING MRP ELEVATION OPERATION OVER 5 DEGREES (CONTINUED)
THAAD0541
WARNING
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment or
severe burns or electrical shock to personnel.
Step 10.
Remove right heater compartment cover (TM 9-2320-325-14&P). Disconnect ECU
vehicle/selector harness connector MC10 (gray connector). Check for continuity across
wire 114 from connector MC10, terminal V2 to relay 10 connector, terminal 85.
a.
If there is continuity, replace transmission ECU (TM 9-2320-325-14&P).
b.
If there is no continuity, repair ECU vehicle/selector harness wire 114
(TM 9-2320-325-14&P) or notify Supervisor.
Step 11.
Disconnect engine harness connector MC5.
Check for continuity across wire 151-D
from connector MC5, terminal R to a known good ground.
a.
If there is continuity, repair ECU vehicle/selector harness wire 151-D
(TM 9-2320-325-14&P) or notify Supervisor.
b.
If there is no continuity, repair engine harness wire 151-D
(TM 9-2320-325-14&P) or notify Supervisor.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
