TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 207 of 1616

TM 9-2320-440-13&P

0024-5

0024

NO HIGH IDLE DURING MRP ELEVATION OPERATION OVER 5 DEGREES (CONTINUED)

THAAD0538

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

Step 5.

Remove relay 10 (TM 9-2320-325-14&P). Check for continuity across ECU vehicle/

selector harness wire 1516A from connector MC66, terminal 4 to relay 10 connector,

terminal 86.

If there is no continuity, repair ECU vehicle/selector harness wire 1516A

(TM 9-2320-325-14&P) or notify Supervisor.

Step 6.

Connect jumper connector to ECU vehicle/selector harness connector MC66.

Check

for continuity from wire 151-D at ECU vehicle/selector harness relay 10 connector,

terminal 87 to a known good ground.

If there is no continuity, go to Step 11.

Step 7.

Turn engine start switch ON (

Select N (neutral) on transmission

range selector (

Check for continuity from wire 114 at ECU vehicle/

selector harness relay 10 connector, terminal 85 to a known good ground.

If there is no continuity, go to Step 10.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

TM 9-2320-347-10)

TM 9-2320-347-10)